How to Remove a Door Panel Inside a Toyota Camry

Door panels are an overlooked area of most cars. They are seen and used each time you drive your car, but don't get much attention until something behind them goes wrong. Toyota Camry door panels need to be removed to replace door locks, window glass or to install a keyless entry system. Learn how to remove a door panel inside a Toyota Camry and complete your repair work without having to go to a professional.

Difficulty:

Moderately Easy

Instructions

things you'll need:

• Screw drivers (flat head and phillips head)
• Flat prying tool

Suggest Edits

1. • 1

     Open the door as wide as possible and roll the window up completely. Locate and remove five screws and two clips in the door panel. Two screws are located at the rear of the panel, another two are located under the arm rest, one near the light and the other in front of the light. The last screw is located in the front of the arm rest behind a triangle shaped plastic panel, directly below the door handle. Pry this panel up with a flathead screwdriver to remove the screw underneath. The two clips are near the front of the door and are small plastic circles. Push them in with a small screw driver and pull them out.

   • 2

     Remove the plastic trim around the door handle. Use a flathead screwdriver or prying tool to pop the plastic out from the door panel. Wiggle it around until it comes loose from the door handle.

   • 3

     Use a flathead screwdriver or prying tool at the bottom edge of the door. Pry away from the door until the clips under the edge pop out. These are plastic clips under the edge of the bottom and sides of the panel. Gently pop them out from the entire door panel. The top of the panel is held in place by the window trim. Move the panel back and forth until it is free from the window trim.

   • 4

     Unclip the wire connectors and wires with a flathead screwdriver. The door panel is now free from the door.

Tips & Warnings

• Use a small container or cup to hold loose screws and hardware from the door panel.

• Carefully unclip the wire connectors rather than jerking them apart as this can cause damage.