Minggu, 15 Mei 2011

How to Replace the Front Speakers in a 2002 Toyota Sequoia Limited

How to Replace the Front Speakers in a 2002 Toyota Sequoia Limited

How to Replace the Front Speakers in a 2002 Toyota Sequoia Limitedthumbnail
Car speaker

Speakers work by using a powerful magnet and a thin sheet of material, known as a diaphragm, to create vibrations in the air that produce sound. When the magnet in your speaker is no longer working properly, or the diaphragm tears, the speaker will no longer produce the correct sound, causing a buzz or a hiss to come out of your speaker. If this is happening in the front speakers of your 2002 Toyota Sequoia Limited, you will need to replace the speakers to correct it.

Difficulty:
Moderate

Instructions

things you'll need:

  • Phillips-head screwdriver
  • Flathead screwdriver
    • 1

      Open the front door and pull out the three pins that are along the door jam.

    • 2

      Remove the three plastic panels on the door lining using a screwdriver.

    • 3

      Pry the door handle out of the tabs on the top and bottom of that door handle with a flathead screwdriver.

    • 4

      Slide the door handle towards the back of the car and then pull off the door handle to remove it.

    • 5

      Start at the bottom right corner of the door and begin to remove the door panel by prying it off of the tabs.

    • 6

      Remove the door panel and place it to the side.

    • 7

      Unscrew the screws holding the speaker in place with a Phillips-head screwdriver.

    • 8

      Disconnect the wiring harness from the back of the speaker by pushing in on the tab and pulling to remove the harness.

    • 9

      Connect the wiring harness to the new speaker.

    • 10

      Place the new speaker in the speaker opening and secure it in place with the screws you removed in Step 7.

    • 11

      Place the door panel back onto the door and apply pressure to the entire perimeter of the door panel so that all of the tabs snap back in place.

    • 12

      Reattach the door handle and slide it in place to lock it.

    • 13

      Reattach the three plastic panels and tighten them in place with a Philips-head screwdriver.

Tips & Warnings

  • If you are having trouble prying off the door panel, use a flathead screwdriver wrapped in a cloth to help release the tabs.

Tidak ada komentar:

Posting Komentar