How to Replace the Distributor in a Toyota Tacoma

If you think you need to replace the distributor in your Toyota Tacoma, first be sure you have a model made between 1995 and 1997. The 2.4L, 2.7L and 3.4L engines had distributors. Here's how the home mechanic can replace the distributor; you won't need to buy special tools.

Difficulty:

Moderate

Instructions

things you'll need:

• Breaker bar
• Screwdriver
• Wrench
• O-ring
• Distributor

1. • 1

     Look for the distributor by following the spark plug wires to it. The distributor will be on the left front of the engine block, as you face it. Take off the retaining clips or the retaining screws, depending on the model, and lift the distributor cap straight off. Leave the wiring connected to the cap to make your job easier.

   • 2

     Use a long-handled ratchet (breaker bar) to move the crankshaft bolt in the pulley near the bottom of the engine and rotate the engine to set cylinder No. 1 to Top Dead Center (TDC) mark. For all engines except 2R-E, set the timing mark at 0. On 2R-E, the timing mark should be at 5 degrees.

   • 3

     Unbolt the dust cover with a wrench and mark the position of the rotor relative to the distributor body; then mark the position of the body relative to the block. The position of the distributor and the position of the engine is critical for the spark to go to the proper place at the proper time.

   • 4

     Remove the pinch-bolt holding the distributor in and lift the distributor straight out, away from the engine. Remove and throw away the distributor O-ring.

   • 5

     Apply a light coat of engine oil on a new O-ring and install it.

   • 6

     Match the marks on the distributor with the rotor; place the distributor to align with the mark on the engine block. Place the Tacoma distributor in the block, taking care not to damage the drive gear at the bottom or to move any parts out of alignment. You can order distributor part number 84170N for your Tacoma from Parts Train (see Resources). Other manufacturers will have different numbers, so know your model year and engine size.

   • 7

     Tighten down the pinch-bolt and replace the distributor cap and wires.